Chief Manufacturing RLT1 User Manual download pdf (Page 8)

RLT1 Installation Instructions

Wall Plate Installation

Lag Bolt Installation Instructions

To Install wall plate:

WARNING: It is the responsibility of the installer to verify

that the structure to which the mount is anchored will safely

support five times the combined load of all attached

components and equipment.

1. Determine a suitable mounting location and lift the wall plate

(10) into place.

2. Using a small nail or screw (not provided) in the center hole,

lightly support the wall plate at the mounting location.

3. Level the wall plate (10) and drill pilot holes for anchoring

the wall plate. If drilling into wood studs, use a 15/64” drill

bit.

4. Using four 5/16” lag bolts (210) and 5/16” washers (220),

install the wall plate on the wall.

5. Slide the latches to the outside.

Display Installation

To Install display:

1.Place the display on the wall plate (10) by hooking the hooks

of the brackets (20 and 30) in the top of the wall plate.

(See Figure 7)

2.Secure the display by sliding the latches, one on each side,

inward. (See Figure 7)

3.If desired, install self tapping screws (230) and/or padlocks

(not provided) for additional security. (See Figure 7)

4.Tilt the display up or down as desired.

5.Tighten knobs to achieve the desired tension.

Figure 7

1 2 3 4 5 6 7 8 9 10

No comments

Chief Manufacturing RLT1 User Manual Page 8